||Spektrum compatiable full range telemetry system
||Rx V, Batt. V, current (60A max.), capacity consumed (mAh), altitude selectable absolute or sea level (Altimeter), internal or external temperature measurement selectable, brushless motor RPM (depends on burshless system), telemetry packet missed counter (0 to 100%) for reception estimation
||DSMX (DSM2 Compatible)
||37.5(L) x 27.5(W) x 9(H) mm
||7.3g for Telemetry Electronics, 8.8g for V/I/mAh sensors
||3.45 - 7.2V
RCgroups discussion for Lemon Rx telemetry system
Click to download telemetry user manual
Below is the quick online reference piror to completion of the user manual.
- Industry best size and weight for similiar range and performance
- T-Plug package
- Altimeter, reciever voltage and temperature sensor are all build-in
to the telemetry system
- Full range Spektrum compatiable telemetry system
- Communication protocol is automatically detected for DSMX compatiable
or DSM2 compatiable
- V/I/mAh sensor provides up to 60A of currenting rating and 30V input
- Selectable absolute (accurately measured and clalculated) or sea level
(101.325kPa assumed as being the sea-level atmoshperic pressure for
mathematic calculation) reading by simply turning the pot. dial to minimum
or middle position under the label
- Internal temperature sensor automatically selected as primary sensing if
external sensor is not connected
- mAh counter provides typical of 2.5% accuracy
- Telemetry packet missed counter (0 to 100%) for reception estimation displayed
on "A" variable in telemetry menu
Quick Reference and understanding the product
- Connect all wireharness to the telemetry system with the appropiate
connectors as shown on label.
- Connect the ESC in series with the V/I sensor. Do not connect battery or
any power source to the unit.
- Connect the telemetry system to the receiver bind location.
- Ensure Spektrum transmitter telemetry options are selected and enabled
properly along with the appropiate measurment system (Imperical / Metric)
- Insert bind plug to the telemetry system.
- Excute bind procedure by connecting the battery to the V/I sensor for providing
power to the unit. Both reciever and telemetry system should flash quickly.
- Upon binding, you are now ready to use the telemetry system!
Below is the V/I/mAh sensor. This sensor's T-plug should connect in
series between the battery and ESC.
Below is the external temperature sensor. (The red wire is used for RPM sensing
and it may works with some of the brushless system in the market only. Cut this wire
and connect to any one of the brushless motor's wire. Please change the gear ratio
in Spektrum telemetry RPM setting to around 0.2 for reasonable reading and do fine
adjustement as necessary.)
Below is the wire that connects between the telemetry system and the receiver's bind port.
Telemetry power is obtained via this wire from the receiver and also enable both units binding
to the transmitter.
Example for connecting a receiver and ready for binding.
Enable these features in the Spektrum transmitter. Go inside each of the telemetry option
to ensure that they are enabled for display. Also remember to select Imperical or Metric for the